Publicité
NB : For the fitting to your installation: tighten the fitting or the nuts
securely using a wrench. Avoid excessive tightening, which could
break the thread or cause micro cracks which could expand over
time and the pressure of the water and cause a leak.
[Drawing part 3]
- Identify this fastening point vertically aligned with the water
output on the top of the mixer. For the height, see the the
measurements given in the drawing.
- Drill the wall with 6mm bit with a 40 mm depth in order to
introduce a suitable wall plug into it according to the material of
your wall.
- Place the wall fastening support of the column with the suitable
screw.
[Drawing part 4]
- Insert the wall fastening element. Ensure that the unlocking
button is turn up.
[Drawing part 5]
- Screw the top part of the column into the lower part
[Drawing part 6]
- Engage the column into the wall fastening support
- Engage the lower part of the column into the mixer top connector
with the gasket in between to ensure the water tightness
- Tighten the lower part to the connector with a wrench
[Drawing part 7]
- Tighten the wall fastening support with the hex key
- Connect the flexible to the mixer and tighten with a wrench
- Connect the head of the flexible
- Screw the shower head on the column
Use
The mixer allows you to use either the column head or the hose. To
switch from one to the other, it depends of the position of the
selector on the lower part of the column. The symbols on its
surface inform you about the mode.
Maintenance / cleaning
The proper functioning of the tap therefore requires regular
maintenance.
We therefore recommend:
- never use abrasive or corrosive products. These aggressive
products attack coatings and tarnish your faucet.
- clean the chrome surface using a mild soap or soapy water and a
soft cloth making sure to rinse well with clean water after cleaning.
- regularly clean the cartridge / tap head (at least once a year),
using of a solution of water and white vinegar (let stand overnight).
- clean the aerator-aerator by soaking it in a water / white vinegar
solution.
- activate the moving parts (inverter, lever, crosspiece, pull tab) at
least once per week to ensure smooth operation over time
Publicité
