Installing The Simplicity Infant Carrier On A Silver Cross Travel System; Using The Simplicity Infant Carrier As A Rocking Seat; Using The Simplicity Infant Carrier As A Baby Seat; Looking After Your Simplicity Infant Carrier - Silver Cross Simplicity Mode D'emploi

Installing the Simplicity Infant
Carrier on a Silver Cross travel
system
The Simplicity Infant Carrier is
designed to fit specified Silver Cross
pushchairs. Please refer to your
pushchair instructions.
Using the Simplicity Infant
Carrier as a rocking seat
Place the Simplicity Infant Carrier on
a level floor surface. Move the handle
making sure the handle firmly clicks
into the rocking position (see page 6).
Your baby must be harnessed
into the infant carrier and
never left unattended.
Using the Simplicity Infant
Carrier as a baby seat
Place the Simplicity Infant Carrier on
a level floor surface. Move the handle
making sure the handle firmly clicks
into the stable position. You can now
use the Simplicity Infant Carrier as a
baby seat.
Your baby must be harnessed
into the infant carrier and
never left unattended.
Looking after your
Simplicity Infant Carrier
Removing the covers
You must never use your
Simplicity Infant Carrier
without the manufacturer's cover. It
is an important safety feature of the
infant carrier.
18
To remove the cover, open the velcro
fastening chest pads and remove.
First remove the head support cover
by opening the two press studs and
remove the head support cover from
the plastic insert.
To remove the cover, undo the two
press studs, undo the harness buckle
and then pull out the eight connecting
studs situated at the sides of the
cover. Slide the harness and buckle
through the cutouts in the cover, pull
the cover over the sides of the infant
carrier and remove the cover.
Refitting the covers
Pull the cover over the sides of the
infant carrier. Make sure the internal
safety harness is threaded through
the cutouts in the cover. Insert the
cover into the sides of the two blue
seatbelt guides and the two sun/wind
canopy connection points. Fasten the
eight connecting studs, and the two
press studs to complete the refitting
of the cover.
Slide the head support cover over the
plastic insert, and slide the shoulder
straps through the head support
cover, fasten the two press studs to
complete the refitting of the cover.
Open the velcro fastening on the
chest pads and refit.
Make sure there are no twists in the
harness.
It is very important that the
chest pads are refitted. They
are an important safety feature,
and should always be used.