ELWING E1-500 Mode D'emploi page 12

Change the Ride Mode
This board ships in beginner mode. Before following the instructions
below to switch modes, make sure you have mastered the use of the
remote and board.
Click on the B button to switch mode. The four LEDs will show the selected
mode by flashing more or less quickly.
WARNING
: The Throttle Wheel is much more sensitive in 2nd and 3rd mode.
To avoid getting thrown off the back of the board, follow these tips:
• Start by moving forward as slowly as possible.
• Move the Throttle Wheel in small increments.
• Keep a wide stance on the board.
• Keep a low center of gravity.
• Lean forward when accelerating.
• Lean backward when braking.
LEDs will flash one by one
(from one end to the other end)
when the differents modes
are changed.