Velleman HAA86C Notice D'emploi page 2

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying the HAA86C! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
The HAA86C has a card capacity of 1,000,000 and has 4 door-opening modes:
1. With card only
2. With card + PIN code
3. With card only or by pressing a key
4. Free-access mode
2. Settings & Activation
Use a knife or another sharp object to free the small frame around the keypad from the housing. Remove the four
screws and take out the front panel. You can now set the hardware to your requirements through the 8 jumpers (JP1
through JP8 in the wiring diagram on the last page).
The alarm output is activated for 4 seconds when the device is activated. The two-colour LED will flash (red) and the
user will hear one long and two short beeps. The device is now ready for use.
3. Description
1. Card-Only Mode
2. Card-&-PIN-Code Mode
3. Key Mode
4. Free-Access Mode
5. Password Mode
HAA86C_v3
HAA86C – ACCESS CONTROL PANEL
: the door will be opened when the card is held in front of the reader. The
card is marked with a 6-digit ID. Before using this mode, enter the ID
number into the reader.
: hold the card next to the reader and enter the 4-digit common PIN code
(=6890 in our example).
How does the common PIN code work?
This simply means that everyone has a different card but uses the same
PIN code to open the door. The common PIN code always consists of 4
digits and only one common PIN code can be used at a time.
: the door will open by entering the 6-digit ID code or any 6-digit PIN code.
: any electromagnetic card can open the door without entering the card ID.
This mode can be used to test the reader. It is recommended not to use
this mode as only the card can open the door.
: this is the code for entering the command mode.
2 VELLEMAN