Table des Matières
Publicité
Installing the Appliance
WARNING:
For your safety, follow all instructions listed in this section.
Install in a location away from direct sunlight and sources of heat. A maximum ambient temperature of
1
104º F (40º C) is recommended.
Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios,
2
transmitters, and broadband amplifiers.
The included power cord(s) are approved for use only in specific countries or regions. Before using a
3
power cord, verify that it is rated and approved for use in your location.
Ensure that no water or excessive moisture can enter the unit.
4
Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of
5
1 inch (25.44mm) clearance is recommended.
Consideration must be given to the connection of the equipment to the supply circuit. Appropriate
6
consideration of equipment nameplate ratings must be used when addressing this concern. Do not
overload the circuit.
Reliable grounding of power supply must be maintained. Particular attention must be given to power
7
supply connections other than direct connections to the branch circuits, such as power strips.
When using a Fiber Optic Small-Form Pluggable (SFP) module, ensure it is IEC 60825 certified and a
8
Class 1 Laser Product.
This equipment is not intended for use at workplaces with visual display units, in accordance with §2 of
9
the German ordinance for workplaces with visual display units. To avoid incommoding reflections at
visual display workplaces this device must not be placed in the direct field of view.
Lithium Battery Warning
The Lithium Battery used in the SonicWall security appliance may not be replaced by the user. Return the
SonicWall security appliance to a SonicWall-authorized service center for replacement with the same or
equivalent type recommended by the manufacturer. If, for any reason, the battery or SonicWall security
appliance must be disposed of, do so following the battery manufacturer's instructions.
Cable Connections
All Ethernet and RS232 (Console) cables are designed for intra-building connection to other equipment. Do not
connect these ports directly to communication wiring or other wiring that exits the building where the
SonicWall appliance is located.
Power Supply Information
If the power supply is missing from your SonicWall product package, please contact SonicWall Technical
Support at
https://www.sonicwall.com/support/contact-support
for a replacement.
Safety and Regulatory Information
SonicWall TZ570W
3
Publicité
Table des Matières
