Troubleshooting; Your Router Was Not Successfully Set Up; Your Internet Cable Is Not Plugged In Message - Linksys EA6350 V4 Mode D'emploi

Troubleshooting

You can find more help from our award-winning customer support at Linksys.com/support/EA6350 V4.

Your router was not successfully set up

If Linksys Smart Wi-Fi did not complete the setup, you can try the following:

Press and hold the Reset button on your router with a paperclip or pin until the LED starts blinking
(about 10 seconds). Install the router again.

Temporarily disable your computer's firewall (see the security software's instructions for help). Install
the router again.

If you have another computer, use that computer to install the router again.

Your Internet cable is not plugged in message

If you get a "Your Internet cable is not plugged in" message when trying to set up your router, follow these
troubleshooting steps.

Make sure that an ethernet or internet cable (or a cable like the one supplied with your router) is securely
connected to the yellow Internet port on the back of the router and to the appropriate port on your modem. This
port on the modem is usually labeled ethernet, but may be named Internet or WAN.

Make sure that your modem is connected to power and is turned on. If it has a power switch, make sure that it is
set to the ON or l (as opposed to O) position.

If your internet service is cable, verify that the cable modem's CABLE port is connected to the coaxial cable
provided by your ISP.
13