Important Information And Precautions/Warnings - OZ Lifting Products STAINLESS Serie Manuel De L'opérateur

Important Information and Precautions
The information in this manual should be used only for the Stainless Series Push Beam Trolley. This
manual contains general instructions dealing with the normal installation, operation, and maintenance of
the products described herein. The information provided should not be expected to prepare the user for all
possible circumstances.
These products should not be installed, operated, or maintained by any person who has not read all the
contents of these instructions. Failure to read and comply with these instructions, warnings, or limitations
noted might result in bodily injury, death, or property damage. Contact the distributor for further explanation
if information is not fully understood.
It is the responsibility of the owner/user to install, test, maintain, and operate these products in accordance
with OSHA, regulations, other federal, state, and local regulations, and ASME standards.
Only trained and qualified personnel shall operate and maintain this equipment.
Maintain Records
Schedule and maintain records of regular inspection and maintenance of these products. Record the serial
number and purchase date of your trolleys on the front cover of this manual to allow for easier referencing.
Precautions
Do not use these trolleys in conjunction with other equipment unless the system designer, manufacturer,
installer, or user has put the necessary safety devices in place. Modifications to upgrade or alter these
products should only be authorized by the original manufacturer.
These trolleys should be used for holding loads only within their load ratings..
Standards: CE, AS1418.2, ASME B30.11, ASME B30.16
(For use with manual or powered hoists)
Warnings
Failure to read and comply with the following warnings may result in a hazardous situation that
could lead to death, serious injury, or property damage.
Be sure to properly install, operate, and maintain the trolleys so they do not come off the beam.
Do Not lift more than the rated load.
Do Not lift people or lift loads over people.
Do Not operate with side or off center loading of load.
Do Not operate a damaged or malfunctioning product.
Do Not remove, deface, or cover warning labels.
Do Not leave a suspended load unattended, unless specific precautions are instituted.
Do Not operate until personnel are warned and cleared from the area.
Do Not operate if locking nuts are not tight and locked in position.
Do Not operate if space washers are not correctly spaced.
Do Not operate if end stops are defective and don't restrain the trolley.
Do Not use if load is not suspended vertically.
Do Not use trolleys as welding ground.
Do Not weld on the lifted load.
Do Not allow the load to swing.
Do Not use for any function other than that for which the product is designed.
EN pg.4