Electrolux FI23/11NDV Notice D'utilisation page 14

14 www.electrolux.com
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FastFreeze,
or after changing the tem‐
perature.
The compressor does not
start immediately after
pressing the Shopping, or
after changing the temper‐
ature.
Water flows inside the re‐
frigerator.
Water flows on the floor.
Temperature cannot be
set.
All manuals and user guides at all-guides.com
Possible cause
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed
correctly.
The FastFreeze is
switched on.
The Shopping is switch‐
ed on.
This is normal, no error
has occurred.
This is normal, no error
has occurred.
The water outlet is clog‐
ged.
Food products prevent
that water flows into the
water collector.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
The FastFreeze mode or
Shopping mode is
switched on.
Solution
Refer to "Operation".
Wait some hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door".
Refer to "FastFreeze mode".
Refer to "Shopping mode".
The compressor starts after
a period of time.
The compressor starts after
a period of time.
Clean the water outlet.
Make sure that food prod‐
ucts do not touch the rear
plate.
Attach the melting water out‐
let to the evaporative tray.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto‐
matically to set the tempera‐
ture. Refer to "FastFreeze
mode" or "Shopping mode".