Product Operations And Settings; Product Operations - Victure HC200 Manuel De L'utilisateur

All manuals and user guides at all-guides.com

Product Operations and Settings

Product operations

This machine has three modes: OFF/TEST/ON
OFF mode - When the camera in this mode, the machine is off.
TEST mode - When the machine in this mode, you can set up the
camera; you can manually take pictures, videos or playback photos.
Under this mode, the red LED flashing shows the PIR sensor is
working.
ON mode - When mode switch in the "ON" position, the camera will
count down for 5 seconds, indicating that the PIR sensor is start to
work. After 5 seconds the display goes out, at this time the product
will work automatically and the LEDs will not flash:
A. When an animal enter into the PIR sensor area, the camera will
quickly start and shoot. After shooting the camera will be stand-by.
B. Every shot done, the camera will be in the auto-sensing detection
mode once again after 1 minute. When there is another animal
moving in the sensor area, the camera will turn on automatically to
take pictures or record videos again, repeat like this.
Tips:
1. The product's default interval is 1 minutes, you can set your own for
5-59 seconds or 1-60 minutes.
2. Before entering the ON mode, please set related parameters in
8