Philips SONICARE 3000 Serie Mode D'emploi page 13

2 Place the toothbrush bristles against the
3 Press the power on/off button to turn on
4 Gently keep the bristles placed on the teeth
5 To clean the inside surfaces of the front
6 Begin brushing in section 1 (outside upper
1
2
4
3
teeth at a slight angle (45 degrees), pressing
gently to make the bristles reach the
gumline or slightly beneath the gumline.
Note: Keep the center of the brush in
contact with the teeth at all times.
the Philips Sonicare.
and in the gumline. Brush your teeth with
small back and forth motion so the bristles
reach between the teeth. Continue this
motion throughout your brushing cycle.
Note: The bristles should slightly flare. It is
not recommended to scrub as you would
with a manual toothbrush.
teeth, tilt the brush handle semi-upright
and make several vertical overlapping
brushing strokes on each tooth.
Note: To make sure you brush evenly
throughout the mouth, divide your mouth
into 4 sections using the Quadpacer feature
(see chapter 'Features').
teeth) and brush for 30 seconds before you
move to section 2 (inside upper teeth).
Continue brushing in section 3 (outside
lower teeth) and brush for 30 seconds
before you move to section 4 (inside lower
teeth).
13
English