Assembling Your Smoothie Maker - Focus Electrics BACK TO BASICS SMOOTHIE CLASSIC Manuel D'instructions

A
SSEMBLING
Before assembling your smoothie maker, wash all parts, except for the motor base
in warm, soapy water, rinse thoroughly and dry. Unscrew and disassemble the valve
for cleaning (see Cleaning Your Smoothie Maker section). To prolong the life of your
smoothie maker, do not wash parts in the dishwasher.
1. Position the rubber gasket down onto the circular flat surface in the blade base.
2. Screw the blade base on the bottom of the blending jar by twisting the blade
base clockwise until tightened. Make sure that the blade base is tightly fastened
to the blending jar and that the rubber gasket is properly compressed between
the blending jar and the blade base.
3. Place the lid onto the top of the blending jar. Place the lid cap in the center of
the lid or place the stir stick through the center of the lid if blending liquids or
frozen drinks.
4. Place the blending jar onto the motor base so that the bottom of the blade base
is sitting flat on the motor base.
5. Plug in the cord.
6. Your smoothie maker is now ready to use.
Stir Stick
Lid Cap
Lid
Blending Jar
Blender Cap
Dispensing Valve
All manuals and user guides at all-guides.com
Y
OUR
4
S M
MOOTHIE AKER
Rubber Gasket
Blade Base
Motor Base