Epson BO-QC2000 Manuel D'utilisation page 12

• If the LED does not light, check that the AC adapter and AC cable are
connected correctly and that the battery is inserted correctly.
• If the LED is flashing (error state), check that the battery is inserted
correctly and that the temperature is within the possible charging range.
If the error cannot be resolved, contact your dealer or a Seiko Epson
service center for advice.
When charging is complete, remove the battery from the spacer.
If the spacer becomes detached from the quad battery charger, attach it again. Push it in
until you hear a clicking sound.
Cleaning the Quad Battery Charger
Make sure the AC cable is disconnected from the outlet and then wipe off any dirt with a
dry or slightly damp cloth.
!
CAUTION:
Do not use alcohol, benzene, thinner, trichloroethylene, or ketone solvent. Using
such solvents may cause deterioration or damage to the plastic or rubber parts.
Cleaning the Charging Terminals
Charging may not be performed properly if there is dirt or foreign matter on the charging
terminals. Make sure the AC cable is disconnected from the outlet and then wipe off any
dirt with a dry cotton swab. We recommend cleaning the charging terminals regularly
(about once every 3 months).
K
!
CAUTION:
❏
The charging terminals may be very hot after charging. Do not touch them soon after
charging. Wait a while for them to cool before you attempt to clean them.
❏
Take care not to damage the charging terminals with a finger or hard object.
❏
Do not expose the charge terminals to water. Use a dry cotton swab for cleaning.
12