Touch Dynamic Saturn DV J1900 Mode D'emploi page 21

COM1/COM2/COM3 Power Setting
COM1, COM2 and COM3 can be set to provide power to your serial device.
The voltage can be set to +5V or
1. Power on the system, and press
the <DEL> key when the system is
booting up to enter the BIOS Setup
utility.
2. Select the Advanced tab.
3. Select VGA/COM Power and LCD
Brightness Configuration Ports
and press <Enter> to go to display
the available options.
4. To enable the power, select COM1,
COM2 or COM3 Power setting and
press <Enter>. Select Power and
press <Enter>. Save the change
by pressing F10.
12V in the BIOS.
+
11