Emtek EMTouch Guide D'installation Et De Programmation page 11

Keypad Operation - Beeper & LED Indicators
Function
Valid Code
Invalid Code/Access Denied*
Lock-Out Mode Error
Access Accepted
Low Battery
Blackout Battery**
Button Press Accepted
Outside Thumb Turn Enabled
* If 3 consecutive incorrect codes are entered, the lock emits 4 short beeps and a flashing Red EMTEK button. The lock will not
accept additional input for 20 seconds (20 beeps). When the next valid code is entered the lock will beep quickly 3 times to alert
of the incorrect codes.
** Battery voltage has dropped too low; keypad will be disabled but metal key override will still work.
Restoring the Lock to Factory Default Setting
This procedure clears the lock of all users and restores the Programming Code and 2 User Codes
shipped with the lock.
• Press and hold EMTEK button for 3 seconds.
• Enter "000000"
• After 2 beeps and 2 Green LED Flash, remove power
(disconnect 9V battery) from Lock.
• After 5 seconds, restore power (reconnect 9V battery).
• Confirm by 2 beeps and 2 Green LED Flash.
Indicators
• 1 short beep, EMTEK button flashes Green.
• 1 Red LED flash
• 2 short beeps
• 2 short beeps
• 1 short beep per second for duration
• 1 short beep
• 1 Green LED flash
• 4 Red LED flashes
• 4 short beeps
• 1 long Red LED flash
• 4 long beeps
• 1 Yellow LED flash
• 1 Short Beep
• 2 Green LED flashes
U.S. patents:
8,176,761
8,141,400
Canadian patents:
2,698,041
2,789,278
2,789,280
EN EN
11