Getting Started; Important - Olivia Garden Ceramic + ion CI-FL1 Mode D'emploi

WARNING:
DO NOT USE THIS APPLIANCE NEAR
BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER
• When the appliance is used in a bathroom,
unplug it after use since the proximity
of water presents a hazard even when
the appliance is switched off.
• Burn hazard! Keep appliance out of reach
from young children, particularly during
use and cool down.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not
be made by children.
• If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in
order to avoid a hazard.
• For additional protection, the installation of
a residual current device (RCD) having
a rated residual operating current not
exceeding 30mA is advisable in the
electrical circuit supplying the bathroom.
Ask your installer for advice.
• When the appliance is connected to the
power supply, never leave it unattended.
• Always place the appliance with the stand,
if any, on a heat-resistant, stable flat surface.
WARNING: HOT SURFACES
This iron gets extremely hot. Please use caution
when handling. To reduce the risk of burns, fire
or injury to persons:
1. This appliance should never be left
unattended when plugged in.
2. Use this appliance only for its intended
use as described in this manual.
Do not use attachments not recommended
by manufacturer.
3. Keep the cord away from heated surfaces.
4. Never place objects on the iron plates.
The plates get extremely hot and objects
may melt or damage the plates.
5. Do not use outdoors or operate where
aerosol products are being used or where
oxygen is being administered.
6. This unit is hot when in use. Do not let eyes
or skin touch heated surfaces.
7. Do not place the heated unit directly on
any surface (unless it is high heat resistant)
while it is hot or still plugged in.
4
Operating Instructions
This appliance is for salon or household use,
and may be plugged into your AC electrical
outlet (100-240VAC, 50-60Hz). If you are
traveling, use the appropriate adapter to plug
in your electricity outlet. Your flat iron will then
automatically adjust itself to the adequate
voltage and function normally.

Getting Started

IMPORTANT

Keep heated surfaces away from contact
•
with all skin areas and eyes. Do not touch
straightening plates with your fingertips.
• For shorter hair, place a thin plastic
comb between scalp and iron to avoid
touching scalp.
• Test small section of hair before styling
whole head.
PREHEATING
1. Place the iron on a smooth and flat
surface, ideally on your heat resistant
mat, and then plug into the outlet.
2. Press the ON/OFF switch once to turn
the flat iron ON.
3. The LED Digital number will light up.
4. Press the '+' or '-' buttons to adjust to
desired temperature.
5. Allow 1 minute (or less) for flat iron to
reach selected temperature (heat-up time
depends on chosen temperature).
6. To switch the temperature reading from
°F to °C (or vice versa), press and hold
the '+' and '-' buttons simultaneously until
the desired temperature scale is visible.
7. Press the ON/OFF switch for 3 seconds
to turn your flat iron OFF.
STYLING
1. When using the flat iron for styling,
please use caution.
2. Work with hair sections that are no more
than 1-1/2" wide and 1/4" thick.
3. Place hair between hot plates and press
down firmly.
4. Pull through hair, maintaining a constant
tension.
5. Release pressure from handle and allow
hair to slip out. CAUTION: Hair will be
hot. Let hair cool before touching.
6. Repeat until desired result is achieved.
7. Unplug the iron.
8. Keep iron off skin and surfaces until it
has cooled to avoid burning.
5