Maintenance And Repair - Beha-Amprobe 2100-Delta Manuel De L'utilisateur

Resolution
Tolerance
Sensetivity
Low Resistance Indication (L Rx)
Range
Diode Test
General Specifications
LCD overrange
indication
Measurement
area illumination/
Flashlight
Backlight
Temperature
Humidity
Operating altitude
Safety rating
(overvoltage
category)
Safety regulations
Electromagnetic
Compatibility (EMC)
Protection degree
Pollution degree
Approvals,
compliance
Battery
Internal battery
consumption
Battery lifetime
Dimensions
(HxWxD)
Weight
approximately

MAINTENANCE AND REPAIR

According to the operating instructions the voltage tester do
not require any special maintenance for operation. However,
if a malfunction occurs during operation, the measurement
has to be stopped and a further measurement is not allowed.
The unit has to be tested at our factory service department.
Except for the replacement of the battery, any repair of
the instrument should be performed only by an Authorized
Service Center or by other qualified instrument service
personnel.
W
If the instrument is not used for a prolonged period,
the batteries must be removed, as leaking batteries may be
hazardous and cause damages.
Cleaning
Before cleaning, disconnect the voltage tester from all
measuring circuits. If the instruments have become dirty
due to daily use, they can be cleaned with a damp cloth
and a little mild household detergent. Never use aggressive
detergents or solvents for cleaning. After cleaning, do not use
the instrument until it is completely dry.
1 Hz
±(5% +5dgt)
> 10V
<20 Ω, same LED as Rx
Yes
"OL"
White LED
LED
-15...55°C operation;
-20...70°C storage; No condensation
Max. 85% RH
Up to 2000 m
CAT IV / 600 V, CAT III / 1000 V
IEC 61243-3:2014, EN 61243-3:2014,
DIN VDE 0682-401:2015,
IEC/EN 60529
Open jaw: IEC/EN 61010-1,
IEC/EN 61010-2-032
IEC 61326-1
IP64
2
3 V (IEC LR03 /AAA 2x 1.5 V)
Approx. 120 mA
More than 10000 measurements
(<5 s / per measurement)
Approximately 210 x 63 x 37 mm
(6.3 x 2.5 x 1.5 in)
275 g (0.61 lb)
13