Brink 751173 Consignes De Montage page 6

2. Make hole for grommet of the wiring kit
Remove the cover of the storage room on the left trunk side panel and take out the car jack.
Remove the left trunk lining and the left upper rear light. If necessary loosen the wheel house lining.
Drill a 33mm hole on a suitable, even place below the left rear light. Chamfer the hole, apply an anti-
corrosive fluid for rust protection and let it dry.
3. Mount 10-core wire set and trailer socket
Route the wire end with the seven single wire clips to the trailer socket holder sheet and put it
through the hole. Place the socket sealing onto this wire end.
Connect the single wire ends to the contact insert according the below mentioned table and
tighten the screws proper:
Wire
black/white
grey
brown
black/green
grey/red (2x)
black/red (2x)
grey/black (2x)
Push the contact insert into the socket housing and push the rubber sealing to the socket's rear side.
Then use enclosed screws M5x35 and nuts M5 to mount the socket onto the socket holder sheet as
follows:
CAUTION!
a) When mounting the socket, some care should be taken to ensure that the wires do not become
trapped and damaged.
b) Ensure that the seals are seated properly. In particular, the seal at the cable exit from the socket
must sit on the insulating tube, not just on the single wires.
c) Lay the cable set so that no chafing can occur anywhere.
d) Do not lay the cable set near to the exhaust system!
052648a020216
Contact # Function
1/L Direction indicator, left side
2/54g Rear fog light of trailer
3/31 Ground
4/R Direction indicator, right side
5/58R Rear parking light, right side
6/54 Brake lights
7/58L Rear parking light, left side
6 / 12