Innova Full Touch SW/C11FTSALMON Manuel De L'utilisateur page 13

measurement.
6. Q: Why does the blood pressure value deviate
from the sphygmomanometer?
Answer: The deviation between the measures values of the
bracelet and the sphygmomanometer is determined by various
factors. The measurement site os the spygmomanometer is the
brachial artery and the measurement site of the watch is in the
two main branches of the arteriole. Under normal circunstances,
the measured values of aortic blood three to forty. If you use a
watch and a sphygmomanometer to measure at the same time,
because the blood flowing in the artery is in the centrifugal direc-
tion, the sphygmomanometer's bandage will keep the area
below the middle of your elbow under pressure and temporarily
the blood will not flow smoothly to the artery branch below.
Increased tension in the bloos vessels will leas to a greater
deviation of the upper and lower blood pressure measurements.
7. Q. Why can't you wear a watch to take a hot bath?
Answer: The temperature of the bath water is relatively high and
will produce a lot of water vapor, and the water vapor is in the
gas phase. Its molecular radius is small and easily seeps though
the gaps in the shell of the watch. When the temperature drops
down, it will condense into liquid droplets again, which will easily
cause short circuits inside the watch and damage the watch
circuit board, thus damageging the watch.
8. Why is the watch not sensitive to touch?
1. When there is oil or water on the touch screen, it will cause
the touch screen to malfunction. Dry the surface of the watch
with a dry cloth to keep the touch screen clean.
will cause the touch screen to malfunction. Dry the surface of the
watch with a dry cloth to keep the touch screen clean.
2. When there is sweat or water on the finger, it will cause the
touch screen to be insensitive.