Concept CP 2000 Mode D'emploi page 58

EN
6. Put the Water Tank back on the main part of the cleaner and make sure
the Water Filter is installed.
7. Connect the steam cleaner into the mains. Press the power on/
off button, the indicator will light blue.
8. After a few seconds half of the indicator will tum red, meaning the
appliance is ready for use.
9. Press the trigger to release the vapour (on the manual cleaner) (13).
IMPORTANT: Always disconnect the cleaner from the mains prior to
removing the Head or handling the appliance. Always ensure the cleaner
has fully cooled down before removing the Head.
SOLUTION TANK USE
1. Rotate the Solution Tank cap counter-clockwise to open and fill the tank
with a solution fluid (8).
2. Put back the Solution Tank cap and screw it clockwise.
3. Press the foot pedal to the ON position to engage the Solution Tank.
Press the foot pedal to the OFF position to disengage.
IMPORTANT: To prevent solution from leaking ensure the foot
pedal is in the OFF position when the product is not in use.
Empty the solution tank
1. Connect the steam cleaner into the mains. Press the power on/off
button, the indicator will light blue.
2. Remove the Solution Tank (17).
3. Rotate the Solution Tank cap counter-clockwise to open.
4. Pour out the solution from the tank (17). Put back the Solution Tank
cap, screw it clockwise, then put the tank back in its place.
58 CP 2000