Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Guidelines for Using Extension Cords
• If you are using an extension cord outdoors, be sure it is marked with the suffix "W-A" ("W" in Canada) to
indicate that it is acceptable for outdoor use.
• Be sure your extension cord is properly wired and in good electrical condition. Always replace a damaged
extension cord or have it repaired by a qualified person before using it.
• Protect your extension cords from sharp objects, excessive heat, and damp or wet areas.
Recommended Minimum Wire Gauge for Extension Cords (120 Volt)
Nameplate
Extension Cord Length
Amperes
25 Feet
(At Full Load)
0–2.0
18
2.1–3.4
18
3.5–5.0
18
5.1–7.0
18
7.1–12.0
18
12.1–16.0
14
16.1–20.0
12
SPECIFIC SAFETY rULES FOr COrDLESS SOLDErING
IrONS
WArNING:
(GAINED FrOM rEPEATED USE) rEPLACE STrICT ADHErENCE TO PrODUCT SAFETY
rULES. If you use this tool unsafe or incorrectly, you can suffer serious personal injury!
•
Do not touch the heated tip of the soldering iron
•
Be aware that this tool is always in an operating condition,
have to be plugged into an electric outlet.
•
Do not lay a soldering iron on its side
•
Do not place your hands or fingers near the tip of the soldering iron.
•
Always assume that the soldering iron tip is hot
•
Wear eye protection.
equipment marked to comply with ANSI z87.1 standards.
•
Use the soldering iron in a well-ventilated area to avoid breathing fumes.
•
Do not solder live circuits
•
The soldering iron tip is sharp.
other than soldering wire and the workpiece material.
•
Hold the soldering iron by the insulated gripping surfaces when performing
an operation where the tip may contact hidden wiring.
may make exposed metal parts of the soldering iron "live" and could give the operator an electric shock.
•
Do not point the tip of the soldering iron at another person.
•
Never leave the soldering iron unattended while it is in the on position.
•
Do not use or store the soldering iron near flammable or combustible
materials or liquids
the tip.
•
Do not place battery tools near fire or heat
possibly personal injury.
50 Feet
75 Feet
18
18
18
18
18
16
16
14
14
12
12
10
10
8
DO NOT LET COMFOrT Or FAMILIArITY WITH THE PrODUCT
Always use safety glasses with side shields. use only certified eye protection
.
Do not touch the tip or allow it to come in contact with anything
. These materials may ignite when exposed to the high temperatures created by
SAVE THESE INSTRUCTIONS
100 Feet
150 Feet
18
16
16
14
14
12
12
12
10
10
8
.
.
.
.
This will reduce the risk of explosion and
200 Feet
16
14
12
10
8
8
8
6
6
6
because it does not
Tips contacting a "live" wire
5
Publicité
Table des Matières
