Kichler 60 Humble Manuel D'instructions page 10

HANGING THE FAN
Step 8. Slip the coupling cover, canopy cover and canopy onto the downrod. (Fig.
11)
Thread the hanger ball onto the downrod, insert the cross pin through the
downrod and tighten. Tighten the set screw.
Step 9. Lift the motor assembly into position and place the hanger ball into the
ceiling mounting bracket.
Step 10. Tighten three set screws on coupling cover firmly (Fig. 12)
Rotate the entire assembly until the check tab has dropped into the registration
slot and seats firmly. (Fig. 13)
The entire motor assembly should not rotate (left or right) when seated properly.
WARNING: Failure to reattach the cross pin and seat the check tab can cause
the fan to fall from the ceiling during operation. Take special care to make sure
this pin is reattached.
Cross Pin
Hanger Ball
Set Screw
Downrod
Fig. 9
10 | KICHLER.COM
(CONTINUED)
Supply Wire
& Safety Cable
Downrod
Hitch Pin Coupling
Set Screws
Set Screws
Supply Wire & Safety Cable
Ceiling Canopy
Coupling Cover
Retaining Clip
Registration Slot
Fig. 10
Cross Pin
Hanger Ball
Set Screws
Downrod
Canopy
Canopy Cover
Coupling Cover
Coupling
Fig. 11
Ball
Downrod
Canopy Cover
Screws
Fig. 12
Fig. 13