Section 4 − Installation; Specifications; Specifications For Torch - AUTO ARC Quick Cut 4500 Manuel Du Propriétaire

4-1. Specifications

NOTE
*A 30 ampere branch circuit is recommended for maximum performance. Performance on a 20 ampere branch service may be limited due to the circuit
breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.
**A 15 ampere branch circuit is recommended for maximum performance. Performance on a 10 ampere branch service may be limited due to the circuit
breaker or line fuse. Reducing unit output amperage will minimize circuit breaker tripping or blowing a line fuse.
Amperes Input at
60 Hz, Single-Phase
115 V
(+15%)
Rated Output
27 A at 92 Volts DC At 28 max;
35% Duty Cycle
*While idling

4-2. Specifications For Torch

Air-cooled torch for plasma arc cutting (PAC)
35% duty cycle
Safety interlock devices shut down power source
Safety trigger guard
Cutting capacity: see Section 4-1
OM-228 305 Page 10
SECTION 4 − INSTALLATION
If the unit is operated from a 30* ampere, 115 volt circuit or a 15** ampere, 230 volt
circuit, a different input power plug must be installed on the power cord. See
Section 4-9 for instructions.
Rated Output,
230 V
115 V
(+15%)
KVA/KW
14 max; 3.32 KVA
0.30* 0.13* 3.25 KW
Plasma Plasma
230 V Plasma Gas Flow/
KVA/KW Gas
Pressure
4.5 CFM
Air Or
3.25 KVA (129 L/min)
Nitrogen
3.19 KW At 60 PSI
Only
(414 kPa)
Rated
Cutting Cutting
Capacity Max
at 10 IPM OCV
3/8 in 288 Volts
(10 mm) DC