Tare Function; Hold Function; Switching Off - CASO DESIGN L20 Mode D'emploi

4.3 Operation
4.3.1 Weighing
Place the scale on a hard & flat surface. Press the
show 0. Place the food on the scale surface and the weight of the food will appear on the
display.
4.3.2

Tare Function

Place an empty container on the scale. The LED display will now show the weight of
the container.
Press the
and clears the weight of container.
Next put the food into the container on the scale. The weight of the food only will appear
on the display. Remove the food and the container and the scale will show the negative
weight. Press the
about 2 seconds.
4.3.3 Hold-Function
Switch the switch for hold-function on the back of the device to position II. The
hold-function is activated. For example: Place 500 g object on the scale. When
you remove the object the 500 g is still displayed. If you want to weigh a new
object, you must first press
switch on the back of the scale by setting the switch to I. Place the item to be weighed on
the weighing surface and the corresponding weight will be displayed.
4.3.4 Change of measurement units
Press to change between g/kg/oz/lb/ml/fl.oz.
4.3.5

Switching off

The scale turns off when you press
Without any operation the scale will automatically turn off after a little over a minute.
button on the right side of the scale and the LED shows zero "0"
button again and the LED shows zero again after round
button, the display will
. The function can be deactivated via the
for at least 5 seconds.
6