Kichler 49384OZ Guide Rapide

1) To install glass panels:
Insert glass panel inside cage. Place glass panel against
side frame of cage. Raise glass panel up slightly and lower
bottom edge of glass panel into bottom channel.
Place short side of bracket up against top of glass and long
side of bracket up against inside top of cage. Align hole in
long side of bracket with hole on top of inside of cage.
Thread screw onto hole. Tighten screw making sure short
side of bracket remains flat against glass. (DO NOT over
tighten screw.)
2) TURN OFF POWER.
IMPORTANT: Before you start, NEVER attempt any work
without shutting off the electricity until the work is done.
a) Go to the main fuse, or circuit breaker, box in your
home. Place the main power switch in the "OFF"
position.
b) Unscrew the fuse(s), or switch "OFF" the circuit breaker
switch(s), that control the power to the fixture or room that
you are working on.
c) Place the wall switch in the "OFF" position. If the fixture
to be replaced has a switch or pull chain, place those in
the "OFF" position.
3) Thread hexnut onto threaded pipe so that 5 threads are
exposed below hexnut. From underside of mounting strap,
thread long end of threaded pipe into hole in mounting strap
until hexnut touches mounting strap. Tighten hexnut against
mounting strap.
4) Thread second hexnut onto other end of threaded pipe.
Tighten hexnut up against mounting strap.
5) Attach mounting strap to outlet box. (Screws not provided)
6) Make wire connections (connectors not provided.)
Reference chart below for correct connections and wire
accordingly.
Connect Black or
Red Supply Wire to:
Black
*Parallel cord (round & smooth)
Clear, Brown, Gold or Black
without tracer
Insulated wire (other than green)
with copper conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
7) Push fixture to wall, carefully passing threaded pipe through
hole in canopy.
8) Screw threaded cap onto threaded pipe. Tighten threaded
cap to secure fixture to wall.
INSTRUCTIONS FOR MOUNTING FIXTURE OUTDOORS AND/
OR IN WET LOCATIONS.
9) Mounting surface should be clean, dry, flat and 1/4" larger
that the canopy on all sides. Any gaps between the mounting
surface and canopy exceeding 3/16" should be corrected as
required.
10) With silicone caulking compound, caulk completely around
where back of canopy meets the wall surface to prevent
water from seeping into outlet box.
SEE OTHER SIDE FOR CANADIAN FRENCH TRANS-
LATIONS.
VOIR L'AUTRE CÔTÉ POUR LES CANADIENS TRA-
DUCTIONS EN FRANÇAIS.
Date Issued: 10/25/13
Connect
White Supply Wire to:
White
*Parallel cord (square & ridged)
Clear, Brown, Gold or Black
with tracer
Insulated wire (other than green)
with silver conductor
Neutral Wire
For Assembling and Installing Fixtures in Canada
Pour L'assemblage et L'installation Au Canada
BRACKET
SUPPORT
GLASS PANEL
PANNEAU VITRÉ
THREADED CAP
BOUCHON
FILETÉE
866-558-5706
We're here to help
Hrs: M-F 9am to 5pm EST
INSTRUCTIONS
SCREW
VIS
MOUNTING STRAP
COLLLIER DE FIXATION
HEXAGONAL
THREADED PIPE
TUBE FILETÉ
CAGE
CAGE
HEXNUT
ECROU
IS-49384-CB