Looper Cover; Spool Stand; Preparation For Threading - Texi Integra 5 Mode D'emploi

LOOPER COVER

1. Push the looper cover to the right until it is stuck.
2. Open the looper cover in the direction of the
arrow.
Note: For safety, please turn off the power before
opening the looper cover!

SPOOL STAND

PREPARATION FOR THREADING

Texi Integra 5 INSTRUKCJA 2019-ALL.indb 91 Texi Integra 5 INSTRUKCJA 2019-ALL.indb 91
Pull the spool stand before put the spool
holder on the spool pin.
Pull up thread guide pole to the highest
point. Place thread spools on pins and draw
thread through thread guides on the pole
from rear to front.
For large cone spools use the rubber spool
holders with the wide end at the top, and
for small ones, use the same rubber spool
holders but with the narrow end at the top.
Texi Integra 5
EN
91
18.09.2020 10:39 18.09.2020 10:39