Lacor 220 Serie Conseils D'utilisation Et D'entretien page 48

2.- Then, insert the attachment (8) and turn the anchor nut (7) counter-clockwise to secure it.
3.- Plug the blender in to a 220-240V/50-60Hz outlet.
4.- To start the blender, follow the steps below:
A.- Push the safety button (1)
B.- While keeping the safety button pushed, push the power button and the motor will
start spinning.
C.- Push the lock button (4) to keep the blender running continuously. The motor will
keep running indefinitely so you can use both hands to work more ergonomically.
5.- If you're using a model with variable speed, turn the speed control (2) and change the speed
to between 4.000 and 16.000 r.p.m.
6.- If you're using a model without variable speed, the speed doesn't change and by default it will
spin at a constant speed of 16.000 r.p.m.
7.- To turn off the blender push the power button again and the motor will stop running.
8.- Unplug the blender after each use.
NOTE:
If you want to use the whisk attachment (10), the procedure is exactly the same as
described in this section.
48