Typical Connection And Cable Section - vds IBIS Manuel Technique D'installation

TYPICAL CONNECTION AND CABLE SECTION

Note:
The control board can be
supplied in one of the two motors
4X0,75mm2
4X0,75mm2
3X1,5mm2
230V Line
CONSIDERATIONS FOR INSTALLATION
· The installation and testing operations must be performed solely by qualified
personnel in order to guarantee the proper and safe operation of the automatic gate.
· The company declines any responsibility for damage caused by incorrect
installations due to incompetence and/or negligence.
· Before assembling the automatism, check that the gate is in perfect working
order, hangs well on its hinges and is suitably lubricated. It must also comply
with the safety standards in force in the country of installation.
1. Before fastening the plates provided,
establish the coordinates using the data
given in Table 1 in accordance with the
wing opening angle (see Fig. 1).
2. Fasten the support plate of the motor
firmly.
3. Fix the motors to the plates.
Table 1
90° OPENING
A
B
2X1,5mm2 (24 Vdc )
2X0,75mm2
RX Photocell
INSTALLATION
13 cm
30 cm
TX Photocell
2X0,75mm2
20mm
A
120° OPENING
A 19 cm