FlyCamOne HD V-Eyes Manuel D'instructions page 12

Start- Up
For using the V-Eyes together with the FlyCamOne HD the video transmission set (FCHD03)
is essential.
Slide on the V-Eyes Baseon the receiver unit and lock it(Open the receiverby sliding the
battery compartment).
Plug the goggles cable in the jack at the bottom of the V-Eyes Base.
Now switch on all elements (camera, sender, receiver and V-Eyes Base).
Choose the same channel on sender and receiver. The live image of the camera will now
appear on the goggles.
You have two possibilities to transfer Head-Tracking to the camera.
The LinX control, that allows to operate the functions,is integrated in the base (FlyCamOne
HD 1080p) – please plug in the antenna for this – the range amounts to 160m then.
Video receiver LinX-
Antenna cable
PPM-Cable Cable to goggles
for trainer-
port
The second option is the transfer through a trainerportof an appropriate RC System.
To do this, connect the base with a suitable trainer port cable to your system. For this
option,please connect the camera with a suitable RX- Cable to your receiver. „Zoom" and
„Start/Stop" can be configured through two free channels. Take this setting fromthe RX-Cable
manual (1080p).
12