Specifications - Wilson Electronics weBoost Drive Reach Fleet Guide D'installation

______

Specifications

Model Number
FCC ID
IC ID
Connectors
Antenna Impedance
Frequency
Power output for single cell
phone (Uplink) dBm
Power output for single cell
phone (Downlink) dBm
Noise Figure
Isolation
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without
factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order
to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a
signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster
will automatically turn the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal
operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the
Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster's microprocessor.
The term "IC" before the radio certification number only signifies that Industry Canada technical specifications were met. This device
complies with Part 15 of FCC rules. This device contains licence-exempt transmitter(s)/receiver(s that comply with Innovation, Science
and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may
not cause interference, and (2)) This device must accept any interference, including interference that may cause undesired operation of
the device. Changes or modifications not expressly approved by weBoost could void the authority to operate this equipment.
DRIVE REACH FLEET PROFESSIONAL VEHICLE SIGNAL BOOSTER KIT
698-716 MHz, 728-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
700 MHz 700 MHz
Band 12/17 Band 13
25.4 25.6
700 MHz 700 MHz
Band 12/17 Band 13
4.8 4.8
Drive Reach
460061
PWO460061
4726A-460061
SMA-Jack
50 Ohms
Maximum Power
800 MHz 1700 MHz
Band 5 Band 4
25.6 26.7
800 MHz
2100 MHz
Band 5
Band 4
4.6
4.8
5 dB nominal
> 90 dB
12 V 1.8 A
1900 MHz
Band 2/25
26.9
1900 MHz
Band 2/25
4.5
15