Belkin TuneFM F8Z061EA Mode D'emploi page 8

Storing and Using Presets
1. To store a preset, select the desired frequency using
the desired preset button (1, 2, 3, or 4) for two seconds. An audible beep sounds
in the transmitted audio when the new frequency is programmed*. The iPod nano
display reflects the change when the memory button is released by showing
which memory button was pressed followed by the frequency saved in that
memory position.
* Do NOT remove the TuneFM from the iPod nano until it returns to the Main Menu
screen or new settings may not be saved.
2. To transmit over one of your preset frequencies, momentarily press "1", "2", "3", or "4".
This will instantly tune the FM transmitter to the frequency stored in that preset.
Storing and Using Presets | 05
or
buttons. Press and hold