Table des Matières
Publicité
SM4018V
Switch
Sequential Fire
Operation
Switch
Bump Fire
Operation
8
OPERATING THE TOOL
METHODS OF OPERATION
1
Sequential Fire Trigger
The switch is in the right position as shown in the
1
illustration at the left. (1 staple)
ƒ To be used in applications where precise fastener
placement is preferred.
ƒ This trigger reduces the chances of double firing and
unintentional firing.
1. With your finger off the trigger, press the safety all the
way down on the surface of the material the fastener
is being driven into.
2. Pull the trigger firing a fastener into the material.
2
3. The tool will not fire again until the trigger is released
2
and the safety is removed completely from the
material being used.
4. To fire the next fastener, repeat the above steps.
Bump Fire Trigger
The switch is in the left position as shown in the
illustration at the left. (3 staples)
3
ƒ To be used in applications where high production work is
being preferred.
ƒ Precaution must be taken when using this style because
3
unintentional firing can occur if trigger is pulled and the
safety is pushed down.
1. With your finger pulling the trigger, press the safety
all the way down on the surface of the material the
fastener is being driven into.
2. This will result in a fastener being driven into the
material.
3. To fire another round, raise the safety completely off
the material and repeat the above steps.
ƒ Caution: do not carry tool with trigger
depressed. This could result in accidental
firing of the tool.
Interchange Brands Staplers: Operator's Manual
Publicité
Table des Matières
