cecotec BOLERO DRESSCODE WASH&DRY 10700 INVERTER Manuel D'instructions page 27

ENGLISH
Connection between screw tap and inlet hose. Fig. 9.
Tap with threads and inlet hose.
Special tap for washing machine.
Connect the other end of inlet hose to the inlet valve at the backside of product and fasten the
pipe tightly clockwise. Fig. 10.
Drain hose
Note: Do not kink or protract the drain hose.
Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
In a drainpipe. It is recommended to use a vertical tube.
In a sink's drainpipe, over the trap.
Fig. 11.
If the machine has drain hose support, it can also be installed on a sink or a tank, like the
following. Fig. 12.
Warning: When installing drain hose, fix it properly with a rope. If drain hose is too long, do not
force it into washing machine as it will cause abnormal noises.
4. OPERATION
Note:
Please make sure the appliance is properly installed before operating it.
Run one whole cycle while the appliance is empty before using it for the first time.
Calibration
It is recommended to calibrate the appliance. To do so:
Empty the washing machine.
Plug it in.
Turn the appliance on and press Speed and Delay at the same time within 10 seconds. The
display will show "t19".
Press the Start/Pause button for the appliance to start washing. The display will show "****".
QuickStart
Before washing
Plug the appliance to a power supply.
Open the tap.
52
Load.
Close the door.
Add detergent.
Fig. 13.
Note: Detergent must be added in "case I" only after selecting pre-washing for machines with
this function.
Washing
Turn the device on.
Turn the knob to select the desired programme.
Select function or use the default one.
Press Start.
Fig. 14.
Note: If any of the default options is selected, step 3 can be skipped.
After washing
The appliance will beep, or the display will show "End".
Using the washing machine
Before each washing
The washing machine should be operated within a temperature range of 0-40 °C. If used under
0°C, the inlet valve and draining system may be damaged. If the machine is placed or operated
in rooms at 0 °C or below, it should be transferred to normal ambient temperature to ensure
the water supply hose and drain hose are not frozen before use.
Check the labels and the product instructions when using detergent before washing. Use
non-foaming or less-foaming detergent suitable for machine washing.
Check the label. Fig. 15.
Empty the pockets of the clothes to be washed. Fig. 16.
Knot the long strips, close zips or tighten button. Fig. 17.
Put small clothes inside a pillow slip. Fig. 18.
Turn easy-pilling and long-pile fabrics inside out. Fig. 19.
Separate clothes with different textures. Fig. 20.
Detergent dispenser
Fig. 21.
Pull out the dispenser to open it.
Pres-wash detergent
Main wash detergent
Softener
ENGLISH
BOLERO DRESSCODE WASH&DRY 10700 INVERTER
53