Neptronic ITO3-C Guide Rapide

Technical Data
Set point range
Sensor NTC
Electrical connection
Operating temperature
Storage temperature
Potentiometer
Relative Humidity
Ingress protection
Application
Dimensions
B
Dimension Inches Metric (mm)
A
B
C
D
Mounting Instructions
A
A. Remove the screw (captive) holding the base and the front cover of the room set point sensor enclosure.
B. Lift the front cover of the enclosure to separate it from the base.
C. Pull wire through the base hole.
D. Secure the base to the wall using wall anchors and screws (supplied). Make the appropriate connections.
E. Mount the control module on the base and secure using the screw.
Recycling at end of life
At end of life, please return the electronic control to your Neptronic® local distributor for recycling. If you need to find the nearest
Neptronic® authorized distributor, please consult www.neptronic.com.
ITO3-201109
Features:
•
•
ITO3-C
Scale Celsius
14ºC to 30ºC
Weight
The temperature set point adjustment without sensor ITO3 series must be used with a duct
temperature sensor from Neptronic® to control a DF series Duct heater, a BM023C actuator or a
TCA or VVC controller from Neptronic®
D
A C
3.00 78
3.00 78
1.00 24
2.36 60
B
Specification & Installation instructions
Celsius or Fahrenheit scale
Sensor 3.3 KΩ or 10 KΩ
ITO3-F
Fahrenheit
57ºF to 86ºF
3.3 KΩ
2 wires or 3 wires 0.8 mm
2ºC to 35ºC (35ºF to 95ºF)
0ºC to 50ºC (32ºF to 122ºF)
2.5 K ohms
5 to 95 % non condensing
IP 30 (EN 60529)
68 g. [0.15 lb]
PCB
C
Wall Thermostat
ITO3-11C
Celsius
14ºC to 30ºC
10 KΩ
2
[18 AWG] minimum
Factory calibrated
D
E
ITO3-C
ITO3-F
ITO3-11C
ITO3-11F
ITO3-11F
Fahrenheit
57ºF to 86ºF
Page | 1