Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Minimum Gauge for Cord Sets
Volts
Total Length of Cord in Feet
120 V
25
(7.6)
240 V
50
(15.2)
Ampere
Rating
Not
More
Than
More
Than
0
6
18
6
10
18
10
12
16
12
16
14
• Do not place any object on top of the charger
or place the charger on a soft surface that
might block the ventilation slots and result in
excessive internal heat. Place the charger in a
position away from any heat source. The charger is
ventilated through slots in the top and the bottom
of the housing.
• Do not operate the charger with a damaged
cord or plug.
• Do not operate the charger if it has received
a sharp blow, been dropped or otherwise
damaged in any way. Take it to an authorized
service center.
• Do not disassemble the charger; take it to an
authorized service center when service or repair
is required. Incorrect reassembly may result in a risk
of electric shock, electrocution or fire.
• Disconnect the charger from the outlet before
attempting any cleaning. This will reduce the
risk of electric shock. Removing the battery pack
will not reduce this risk.
• NEVER attempt to connect two chargers together.
• The charger is designed to operate on standard
120V household electrical power. Do not
attempt to use it on any other voltage. This does
not apply to the vehicular charger.
WARNING: Shock hazard. Do not allow any liquid to get
inside the charger. Electric shock may result.
WARNING: Burn hazard. Do not submerge the battery
pack in any liquid or allow any liquid to enter the battery
pack. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks
or cracks, return to a service center for recycling.
8
(meters)
50
100
(15.2)
(30.5)
100
200
(30.5)
(61.0)
American Wire Gauge
16
16
16
14
16
14
12
Not Recommended
CAUTION: Burn hazard. To reduce the risk of injury,
charge only DEWALT rechargeable battery packs. Other
types of batteries may overheat and bust resulting in
personal injury and property damage.
150
NOTICE: Under certain conditions, with the charger
(45.7)
plugged into the power supply, the charger can be
shorted by foreign material. Foreign materials of a
300
(91.4)
conductive nature, such as, but not limited to, grinding
dust, metal chips, steel wool, aluminum foil or any
buildup of metallic particles should be kept away from
the charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity.
Unplug the charger before attempting to clean.
Charging a Battery
14
1. Plug the charger into an appropriate outlet
12
before inserting battery pack.
12
2. Insert the battery pack into the charger,
making sure the battery pack is fully seated in
the charger. The red (charging) light will blink
continuously indicating that the charging
process has started.
3. The completion of charge will be indicated by
the red light remaining ON continuously. The
battery pack is fully charged and may be used
at this time or left in the charger. To remove the
battery pack from the charger, push the battery
release button on the battery pack and then slide
the battery pack out of the charger.
Fig. 2
NOTE: To ensure maximum performance and life of
lithium-ion battery packs, charge the battery pack fully
before first use.
Publicité
Table des Matières
