Led Diagnostics - radioRA 3 Instructions D'installation

Step 5 — System Setup
For more information, please refer to the Getting Started Guide, which can be found
in the RA3 Support Center: www.lutron.com/RA3support

LED Diagnostics

Processor
Mode / Error
Normal Operation
Software Update
Error
Processor Identify
PoE Injector
Mode / Error
Unit is "ON" Active with No Load
Unit has detected an Invalid Load
Unit has detected a Valid IEEE 802.3af Load
Unit is in Over Load/Short Condition
Troubleshooting
Symptom
Unit does not
power on
Unit cannot be
found in setup
software
Unit does not control
surrounding lights
For additional troubleshooting information, please see www.lutron.com/RA3support
Probable Cause
A PoE switch is not being used or is not configured as a PoE switch
The other end of the Ethernet cable is not connected to a PoE switch or injector
Ensure the IN/OUT connections on the PoE Injector are correct (refer to Step 4C)
The Ethernet cable is not connected to the same LAN as the setup software
Ethernet run is longer than the supported 328 ft (100 m) and a PoE extender
is needed
Ensure the IN/OUT connections on the PoE Injector are correct (refer to Step 4C)
Lights are out of range of the wireless processor
Processor lost power / Ethernet wire run too long and PoE booster is required
LED Pattern Description
Status LED blinks green every 10 seconds
Status LED blinks blue
Status LED remains solid red
Status LED blinks green rapidly
LED Pattern Description
Status LED blinks green
Status LED blinks yellow and green
Status LED remains solid green
Status LED blinks yellow
7