Fitting Instructions - Herth+Buss 76121450 Mode D'emploi

Fitting Instructions

Converter
EN
Requirements:
1. The converter is suitable for incandescent
lamps and luminescent diodes (LED) even
with electronic devices.
2. The mounting location must not be ex-
posed to direct splash water (de-icing salt
corrodes).
3. The mounting location must have air circu-
lation (do not wrap in insulation material)
4. All connections must be carried out
carefully. Crimp isolated crimp connectors
well. Insulation displacement connectors
must be used according to the cable size.
Installation:
1. All wires must be dead before tapping.
2. Fix the converter with the M4 screws sup-
plied.
3. First of all make the connection to ground
(negative, clamp 31). Then connect the
seven lines parallel to the loom of cables
on the trailer. Use the ground line of the
cable loom if present. The cables must be
connected as follows (input and output
are the same colour):
www.herthundbuss.com
Rear lamp left and rear lamp right must not
be connected!
Function
Ground
Direction indicator, left
Direction indicator, right
Rear lamp, left
Rear lamp, right
Stop light
Rear fog lamp
4. Use a test lamp to ensure correct function
of the trailer socket.
76121450
Code Colour
31
L
R
58L
58R
54
54g
4