How To Use - Windmere WCO200C Guide Rapide

Product may vary slightly from what is illustrated.



† 1. Removable cutting assembly (part # WC0200C-01)
2. Geared wheel
3. Guide bar
4. Lever
† Consumer replaceable/removable parts
3

How to Use

This product is for household use only.
Note: See C RE ND CLE NING for assembly instructions.
1. Remove all packaging materials before using.
2. Place the can opener on a level surface and plug into 120 V~ 60 Hz

3. Hold can approximately level.
4. Raising lever, place can under guide bar and against geared wheel.
5. Press down on lever to pierce lid of can. This also starts the cutting
6. Grasp the can; then, raise the lever up from the can.
7. Slide the lid away from the magnet. Use caution to avoid injury from
HINT FOR USING THE C N OPENER
• To open extra tall cans, place can opener at edge of counter before
Important: Do not use the can opener for more than 5 minutes at a time.
motor burnout due to overheating.
electrical outlet.
action. Let go of lever and the can will stop automatically when opened.
sharp edge of lid.
wedging can in position for opening.
llow to cool for at least 15 minutes before using. This will prevent
4