Kripsol PEH100.C Mode D'emploi page 10

Proyector Plano:Proyector Plano.qxd 13/05/2010 10:46 Página 10
5.2. ASSEMBLY.
Special attention should be paid to the
position of the underwater light when
fitting it to the wall.
The anchoring of the underwater lights
(part no.14, pages 29-33) is to be fixed
bearing in mind that the cable slot must
be located at the bottom left, as shown
in the diagram figure 2 (page 25).
The recommended distance for the
installation of the underwater light is
500-700mm. from the water level, (see
figure 3, page 25).
The underwater light is received in its
packaging assembled and with the
cabled rolled up in its housing. To
extract the underwater light anchor
(part no. 14, pages 29-33), proceed as
follows:
1 - Remove the underwater light from
its packaging and unroll the cable.
2 - Release the lower part by turning the
cover clockwise.
3 - Release the anchor, part no.14
(pages 29-33) and fix it to the wall.
4 - Follow the steps described in figures
1-3 (pages 23-25).
5 - Before finally fitting the underwater
light, manually check that the hexagonal
plug (no. 11, pages 29-33) is well fitted
and is water-tight, once the excess
cable has been rolled up into its housing
(between the wall and the star), as
shown in figures 4 (page 26).
6 - Fit the cover over the screen, as
shown in figure 5 (page 27) and anchor
it by turning it in the CLOSE direction, as
shown in figure 6 (page 27).
5.3. DISMANTLING.
To replace the bulb, remove the screen
by turning the cover in the OPEN
direction, as shown in figure 6 (page
27).
Once the screen has been removed,
unroll the excess cable from its housing
to place it on the edge of the swimming
pool as shown in figure 7 (page 28).
The screws holding the screen should
now be visible.
Remove the screws as shown in figure
8 (page 28) and replace the bulb. Note
that being a halogen bulb, it should not
be touched with unprotected fingers.
5.4. WARNINGS.
CAUTION
1 - Persons installing or handling
underwater lights must be suitably
qualified and be familiar with the
IEC364-7-702 STANDARD: WIRING IN
BUILDINGS. SPECIAL
SWIMMING POOLS.
2 - Do not handle the underwater light
while it is connected to the power supply.
3 - Do not switch on the underwater
light while it is out of the water.
4 - The bulb should not be powered by
a voltage of more than 12 Volts.
5 - Do not use any type of bulb other
than the KRIPSOL reference item
(LP100.C).
10
WIRING.