Troubleshooting Guide - Daga Flexy-Heat EP Mode D'emploi

Materials will suffer wear and tear over time and after prolonged use.
Unplug the product immediately from the mains in the event of any
breakdown and contact an authorised Technical support service.
In order to prevent any risk of danger, do not open the remote con-
trol or the connection. Only qualified technical personnel from the
brand´s Official Technical support service may carry out repairs or
procedures on the device.
Any incorrect use or improper handling of the product shall render
the warranty null and void. Only an authorised technical support ser-
vice centre may carry out repairs on the product.
B&B TRENDS, SL. disclaims all liability for damages that may oc-
cur to people, animals or objects, for the non-observance of these
warnings
INSTRUCTIONS FOR USE
Prior to connecting the product to the mains, check your power supply
voltage to ensure it is the same as the one indicated on the label in-
cluded on the product. Connect the product to the appropriate mains.
In order to turn on the product, you must select the slider switch on
the control, setting it to position 1, 2 or 3 (Fig.1).
From this time on, the product is operational.
The maximum operation time is 90 minutes, after which the auto-
matic safety shut-down will immediately activate The product will no
longer heat up when in this state.
Select the " 0" position in order to turn off the product before you
disconnect the device from the mains.

TROUBLESHOOTING GUIDE:

Possible operational problems
PROBLEM
The regulator control
does not light up when
the switch is turned on.
RECOMMENDATION
Ensure that the regulator is properly con-
nected to the product and that there is volt-
age in the socket of the mains used and
that the product is properly plugged in.
9