Hama KHL 32 Mode D'emploi page 6

Roller release:
If the laminate sleeve is not inserted or fed evenly,
pushing on the release button (on rear left) will „open"
the rollers so the laminate can be removed and inserted
again.
Device care:
Roller cleaning:
1. Switch the laminator on as previously described.
2. Fold a size DIN A3 piece of paper and push it into the
device with the folded side fi rst.
3. Repeat this again until there are no more traces of
glue on the paper.
Machine cleaning:
1. Switch off the device and unplug it from the power
supply.
2. When the laminator has cooled down clean the
outside with a soft cloth.
Technical data:
- Number of rollers:
- Mains supply:
- Power consumption:
- Max. sleeve thickness:
- Max. lamination width:
- Max. lamination height:
- Warm-up time:
- Lamination speed:
All manuals and user guides at all-guides.com
Four
220 - 240 V~
450 W
150 µm
340 mm
0.6 mm
4-6 minutes
350 mm/min
5