Publicité
Towel Warmer
Installation Procedure
STEP 1
Rough-in Requirements (see figure 3)
1.
The incoming power feed goes to a deep single gang
electrical box (for the controller). This electrical box can be
located anywhere in the room, although we recommend it
be alongside your light switches.
2.
A power feed then goes from the controller electrical box to
a single gang electrical box (for towel warmer). The location
of this electrical box governs the location of your towel
warmer (see figure 2).
3.
Wall studs or plywood backing is required in the wall at all
bracket locations. See figure 2 for bracket locations.
Figure 1
A
B
E
STEP 3
Hardwire Connection (see figure 4)
Do not connect the towel warmer to the power supply until
all instructions have been read and installation carried out in
accord with them. The heating element is 150W, 300W or 450W
depending on the size of your towel warmer – see page 4 for
details. The element conforms to UL standards and the unit to
CSA standards (File ref: 229718).
STEP 2
Installation Instructions (see figure 1)
1.
2.
3.
4.
C
D
Ensure the CSA label is visible.
TURN OFF POWER SUPPLY BEFORE PROCEEDING.
1.
2.
3.
4.
5.
Check all items have been received. You should have
received a towel warmer, hardwire kit, programmable
controller and mounting bracket kit. Read all instructions
before continuing.
Fix wall supports "A" to the wall using the screws provided
and in locations as shown on figure 2.
Assemble the threaded pin "B", the bush "C" with the
threaded head "D", between the second and third upper and
lower tubes of the towel warmer.
Hang and adjust the towel warmer using set screws "E" to
lock pin "B" in the wall bracket "A". Ensure the towel warmer
is firmly and safely fixed.
Feed the electrical cord located at the bottom of the towel
warmer first through the round tube "G" and then through
the cover plate "F" as shown on figure 4.
Complete all electrical connections as shown in figure 3.
Fit tube "G" over towel warmer element sleeve until it meets
the hexagonal chrome collar.
Push cover plate "F" onto tube.
Screw cover plate to electric box with the enclosed screws.
Adjust where necessary.
Publicité
