Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
C
RECIRCULATING
INSTALLATION OVERVIEW
C1.
C2.
C3. Check Blower Motor Orientation
C4.
C5. Mount the Microwave Oven
C6. Install Charcoal Filter
C1
ATTACH THE MOUNTING PLATE
TO THE WALL
A
C
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to
1
Insert the bolts into the mounting plate through
2
reattach the toggle wings to
To use toggle bolts:
Mounting
Bolt
Wall
20
Installation Instructions
(Non-Vented Ductless)
B
D
onto each bolt.
3 4
Bolt End
3
insert the toggle wings into the holes in the wall
to mount the plate.
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
centered under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate
and the wall.
4
to help tighten the bolts.
C2.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for top support screws and a
hole large enough for the power cord to fit through.
• Drill the holes, following the instructions on the
CAUTION
Wear safety goggles when
drilling holes in the cabinet bottom.
Publicité
Table des Matières
