Beamz Pro LF Serie Mode D'emploi page 5

Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are present, and have
been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damage from
shipping or the package itself shows signs of mishandling. Save the package and all packing materials. In the event that the product must be
returned to the factory, it is important that the product be returned in the original factory box and packing.
If the unit has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation
water might damage your unit. Leave the unit switched off until it has reached room temperature.
On the label on the backside of the unit is indicated on this type of power supply must be connected. Check that the mains voltage corresponds to
this, all other voltages than specified, the light effect can be irreparably damaged. The product must also be directly connected to the mains and
may be used. No dimmer or adjustable power supply.
Always connect the unit to a protected circuit (circuit breaker or fuse). Make sure the unit has an appropriate electrical ground
to avoid the risk of electrocution or fire.
Place the unit on a flat surface and in a suitably large area with at
least 50 cm of open space around the unit.
Open the top lid of the water tank.
Fill the water tank with distilled water.
Fill the fluid tank with Beamz fog fluid.
Plug the power cord into the outlet and turn on the unit, put the
power switch to the "ON" position. The LCD display will show "WARMING UP".
After few seconds the LCD display will shows "READY".
Using the LCD display panel, set the unit to the desired operating
mode.
Turn off the unit, put the power switch to the "OFF" position and pull
out the power cord from the outlet.
Before transporting the unit, empty water tank by connecting a tube
to drainage valves.
Use only original Beamz fog fluid. Warranty will be voided if any other
type of liquid is used, improper use of liquid may lead to machine
failure and malfunction.
When display shows "READY", you can start producing haze and adjust the settings via LCD display panel.
Man Vol Out xxx% Adjust the manual volume output within the range of 0% to 100% by
means of the Up/Down keys.
Interval Set xxxS Adjust the interval between 1 to 100S by means of the Up-/Down keys.
Duration Set xxxS Adjust the duration between 1 to 100S by means of the Up-/Down keys..
Volume Out xxx% Adjust the volume output within the range of 0- 100% by means of the Up-
/Down keys.
DMX 512 #xxx Adjust the DMX address for DMX control by means of the Up-/Down keys.
Wind For Class xx Adjust the wind output during the function within the range of 0- 100% by
means of the Up-/Down keys.
Angel Set xx% No function for this model.
Wireless Turn on/off wireless remote
ON / OFF
ON / OFF
Output volume up
Output volume down