CBE BMTG Instructions D'emploi page 10

EN
POSITIONING FOR USE AS A LPG AND
SOPORIFIC GAS DETECTOR
The configuration bridge (see figure "A") must be set
to "position A ".
The detector must be located near the breathing area
of the occupants.
With this setting, the device has a higher sensitivity
and is able to detect
detector is positioned at a height greater than 1.2m, it
is advisable to install a second dedicated device to
detect LPG only.
( select
INSTALLATION
The installation can be built-in (see figure "B") or with the spacer (see figure "C"). The detector can be combined with
the "Modular Plates Berker" series.
Built-in fixing (figure )
may 2027
Replace
EN
Every 10 years
................-.................
WARNING:
the frame as per figure " ".
Each detector is tested and calibrated with the gas in question; the sensor life is 10 years,
but it may be reduced by pollution. After this
10
also the presence of LPG. If the
Configuration bridge (figure A)
A
B
Position "A"
or set on the right)
B
(example)
Write the installation date of the gas detector on the label and apply the label to
B
POSITIONING FOR USE AS AN LPG
DETECTOR ONLY
The configuration bridge (see figure "A") must be set
to "position ".
The detector must be placed 20-40 cm from the floor
to obtain
gas.
59.5 mm
102 mm
time the device must be replaced.
B
an effective intervention in the presence of
A
B
Position "B"
( lector set on the left) se
Wall-fixing with spacer (figure ) C