Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HAP 200
WARNING!
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
4 Device description
The Weller HAP 200 Hot Air Tool with integrated finger switch (3) is
suitable for soldering and desoldering surface-mounted components.
A wide range of nozzles adds to the versatility of the HAP 200 tool.
A push button (3) integrated in the handle is used to control the air
flow. The ionising circuit integrated in the tool ensures that hot air is
static free. The hose and handle are of antistatic design.
The hot air temperature can be set to between 50°C and 550°C
(100°F and 1000°F) using the control unit.
4.1
Technical data HAP 200
Heating output
Heating voltage
Max. air flow rate
Temperature range
Temperature accuracy
Potential balance
The HAP 200 hot air tool has an equipotential bonding conductor
which can be connected in accordance with the operating
instructions of the control unit in use.
5 Commissioning the device
Risk of injury due to hot air and inert gases.
Use caution when operating the hot air tool, because hot air can
cause burns. Caution: use of inert gases in an enclosed area can
cause asphyxiation.
Please read carefully the safety instructions in the attached
booklet, the safety guidelines given in these operating
instructions and the operating instructions of your control unit
before putting the HAP 200 into operation. Also observe the
safety precautions described herein.
1.
Carefully unpack hot air tool HAP 200.
2. Make sure that the control unit is OFF.
3. Place the HAP 200 hot air tool into the stand (4).
4. Insert the electrical connector (1) of the HAP 200 into the 7-pin
terminal jack on the control unit, and lock in place by briefly
twisting clockwise.
5. Push the air hose of the HAP 200 (2) onto the air nipple on the
control unit.
6. Turn on the control unit at the power switch and set the
temperature and air flow. Also read and observe the operating
instructions of your control unit.
200 W
24 V AC
15 l/min
50°C up to 550°C/100°F up to
1000°F
± 30°C/± 80°F
5-7
Publicité
Table des Matières
