Cleaning Operations; After Cleaning; Power Down - Nitty-Gritty SPOT CLINOX Manuel D'utilisation

3.5. C
LEANING OPERATIONS
1. Executed the electrical installation (Chapter 3.4) turn on the machine with the main switch (2) on "I" (ON).
2. Place the operating switch (5) on CLEAN position.
3. Push the button (16) on the torch (12) to pump liquid from tube tank (11) on the pad/brush (14/25). After each pressing,
wait 2/3 seconds before pressing again in order to fill the pump system. At the first filling repeat this operation 4/5 times.
4. Put the pad/brush (14/25) soaked by electrlytic solution (11) on the stainless steel to work. With pressure, clean the weld
until the oxidation is perfectly removed (Picture H).
Pay attention: the pad/brush (14/25) must always be soaked by electrolytic solution (11) otherwise its lifetime will be
reduced (replace the special pad/brush -14/25- whenever it shows remarkable burns or is notably
broken). Never use the torch insert (15) without the special pad (14).
Pay Attention: HOW USING THE BRUSH IN THE CORRECT WAY:
During the pickling, keep the brush in perpendicular position to the welding and
always wet of electrolytic solution.
3.6. A
FTER CLEANING
1. Put the small torch (12) on its support (13).
2. Remove the clamp of the ground cable (9) from the workpiece.
After cleaning/polishing, it is necessary to rinse the weld in order to remove the chemical sediments along the borders, using
Neutralizing solution Inox Fit (18) on a sponge or a cloth, otherwise white stains will appear after some hours and then another
polishing operation will be necessary to remove them (Picture I).
3.7. P
OWER DOWN
1. Put the power switch (2) on "O" position (OFF).
2. Unplug the machine power cable (1).
3. Supply a machine maintenance (paragraph 5).
VERY IMPORTANT
- 20 -