Installation Without Base - Jole i-Gemm 3 Manuel D'instructions

Installation without base

see images -
33 40
!
DO NOT install this infant carrier module on vehicle seats with Lap
Belts.
33
!
This infant carrier module is suitable for vehicle seats with a 3-point
Retractor Safety Belt only.
34
1. Place the infant carrier module onto the vehicle seat where you wish
to put it. Pull the vehicle safety belt out and lock it into the vehicle
buckle, sliding the vehicle lap belt into the side guides of the infant
carrier module.
35
!
The infant carrier module can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the infant carrier
-2
module securely.
35
2. Slide diagonal belt into the rear guide.
3. Pull the vehicle shoulder belt to fasten the infant carrier module
tightly and securely.
37
4. Level line on infant carrier module must be level to the ground when
the infant carrier module is installed.
!
Tension the vehicle safety belt as much as possible, checking that it
is not loose or twisted.
!
After installing the infant carrier module, always check that the
vehicle belts are routed correctly and securely fastened into the
vehicle buckle.
39
5. The hood can be opened completely to protect your child from the
sun uttermostly, just unzip the hook, and then pull the hood toward
front.
40
13
36
38
Use with Strollers
see images -
41 50
Your enhanced infant child restraint is designed to attach to certain
Joie stroller models featuring a special tray, armbar or calf support.
!
Please make sure your stroller can fit the infant child restraint before
purchasing it.
! Never allow more than one baby in the travel system at one time.
!
Please brake your stroller before assembling the enhanced infant
child restraint.
!
Check that the parts used to fix the enhanced infant child restraint
are securely fastened on the stroller.
!
Recline the stroller seat back to the lowest position.
Use with Joie Strollers
To assemble the enhanced infant child restraint on Joie strollers,
please follow these steps:
1. Place enhanced child restraint into stroller so notches in rockers fit
over edge of armbar, tray or calf support. The enhanced child
restraint will then automatically click into place.
!
If armbar has fabric cover, please detach the Velcro on armbar cover
first. -1
43
!
For the stroller with a special calf support, please adjust the calf
support to the vertical position, detach the Velcro, and then lift the
fabric cover.
-1
44
2. Use the straps on both sides of stroller to fix the enhanced child
restraint. & &
45 46 47
!
Try pulling the enhanced child restraint upwards to check that it is
fitted correctly.
& & &
41 42 43 44
14