Storage And Handling - Daniamant RL6 Mode D'emploi

Storage and Handling

— Lights to remain in packaging until ready to fit in liferaft.
— To avoid inadvertent activation, avoid storage with strong magnetic fields.
Installation
The exact method of mounting will depend on the proposed installation. The fixings of the RL6 assembly
have been designed to offer a wide choice of mounting methods.
Light The external lamp has a dome surrounded by a collar with four securing holes.
Battery The battery case of the RL6 has two fixing loops.
The RL6 system uses a unique polarised plug and socket for connection. Once the two lights are con-
nected, they must be disconnected as shown in the picture below.
Ensure O-Ring is Correctly Fitted
Locking Hook Engaged
Operation
When installed for automatic operation, the light will illuminate and flash when the raft is inflated.
Slide switches on the sides of the battery pack may be operated to turn each lamp on or off.
Maintenance
Routine service and battery change
RL6 units are maintenance free, but the following checks should be made at each service of the liferaft:
1. Check date on battery pack and external lamp. Both must be replaced when the expiry date is
reached. Consequently, if the battery or external lamp expiry date is earlier than the next liferaft
service then the units should be replaced.
2. Inspect light and batteries for signs of damage or corrosion.
Plug Fully Inserted
Releasing Locking Hook
2