Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
How to mount the iCamera KEEP on the wall
1. Place the mounting bracket against the wall. Mark screw
hole positions and drill two holes into the wall at these
locations. Leave at least 4.5 inches on top and 1.25 inches
of open space on each side to allow the iCamera KEEP to
move freely.
2. For stone, brick and drywall, insert a wall anchor (included) into each hole. Do not use wall
anchors if wall is not stone, brick, or drywall. Screw the longer screw into the existing holes
or wall anchors. Leave each screw exposed 0.21 inch / 5.0mm out from the wall.
3. Ensure the power cable is plugged in and exits through the base's opening space. Use three
short screws to secure the iCamera KEEP to the bracket.
Publicité
Table des Matières
