Eurofred 3CSA0013 Mode D'emploi page 47

USING THE ARROWS '  ' OR '  ' IT IS POSSIBLE
TO CYCLICALLY SCROLL THROUGH THE INSTALLATION
PARAMETERS:
P1: SELECTION INSTALLATION TYPE
P2: SETTING THERMAL DATA
P3: ANTIFROST PARAMETERS MANAGEMENT ' O AF '
P4: ACOUSTIC SIGNAL MANAGEMENT
P5: LOGIC RELAY SELECTION
P6: INTEGRATION HOURS COUNTER
P7: LOADS WIRING TEST
P8: LIMITATION OF COLLECTOR MINIMUM TEMP. ' MTL '

PRESS THE '  ' KEY TO MODIFY THE
SELECTED PARAMETER.

CONFIGURE DATA FOR EVERY SINGLE PARAMETER AS
EXPLAINED BELOW.

PRESS THE ' esc ' KEY TO RETURN TO THE INSTALLER
' MIDI '
' DATA '
WAIT 20 SECONDS OR PRESS THE ' esc ' KEY TO EXIT
' BEEP '
' ACT '
Note: in the ' installer parameters ' mode all the outputs
' C AH '
are disabled.
' TEST '
All default values are to be considered as
indicative, being they subject to changes due to
the version and without prior notice.
P1: SELECT INSTALLATION TYPE
Pressing the '  ' or '  ' keys will show all the installations
that can be set up (if the probe for the selected installation
has a problem or is left unconnected, that probe will flash
on the display).
To confirm the selected installation press the '  ' key; the
control unit will memorize the choice and the display will
again show the parameter list.
To cancel the selection, press the ' esc ' key. In this case the
control unit will abandon the changes made and will show
again the parameter list.
47
PARAMETERS SELECTION.

THE INSTALLER MODE.